In order to better seal and dust the clean room, there will be two actions, one to control the internal and external dust contact can be quickly isolated and disconnected by installing fast rolling shutter doors; the second is to set up systems such as blowing, purification, and air curtains to circulate the internal air to the outside.

    Recently, in the electrical production workshop in Malaysia, it is not necessary to meet the cleanliness requirements of the food and pharmaceutical industry. The SEPPES zipper fast shutter door can be used to seal and isolate the inside and outside of the workshop. Through the actual case, let's take a look at the detailed performance and parameters of the fast shutter door used in this factory.

    1. Sealing structure: Abandon the traditional brush structure, use zipper to seal, the door curtain and the guide rail are seamlessly connected, the bottom is the bottom edge of the soft airbag, which is tightly attached to the ground; a long dense brush is added above the door head, air inside and outside It will not pass through the gaps around it, and the internal products will be contaminated.

    2. Thickened door curtain: The customer chooses a 2.5mm thick gray door curtain, which is from the same manufacturer as the imported brand Kuofu. There are many dense anti-tear reinforcing ribs inside, and the surface is anti-static structure, which has good dustproof and resistance.

    3. Brand motor: The standard control system of SEPPES fast rolling shutter door adopts the German Frog Pupil brand, which belongs to the frequency conversion system, slow opening and closing, which is a kind of protection for the motor itself, with fast speed, stable performance and low failure rate.

    4. Induction method: At present, there are many kinds of radar, geomagnetic, Bluetooth, etc. for automatic induction on the market. It is recommended that you use the human-vehicle diversion radar. It is set for the induction of people and vehicles, and the induction requirements are few, and there is no need to pre-embed the coil to destroy the ground. , the induction is accurate, and there will be no error induction.